SEA CHANGE: Printing the Xeric, Day 9

So. It snowed. This is the coldest, snowiest April in the past 10 years here in Minnesota, and it's making sure we all pay attention to that fact. It's yet to hit 60 degrees, when in March of last year parts of America were 20 to 30 degrees above average. Thinking I could bank on Winter following some sort of reliable pattern was a mistake. Thinking the small repairs and replacements needed wouldn't knock me flat until I'd finished this print run was also a mistake.

I've made a lot of them in the pursuit of this project - but giving up hasn't been one of those mistakes.

Terrified, worried, freezing, I trudged back out into that tundra and turned on some space heaters and went for it again.



And it went fine.

I KNOW! When have I come onto this goddamn log of events and said things went WELL? OR BETTER THAN EXPECTED?

Today, for starters. I think I've figured out the root problem of my issues - and yes, Clint was/is right. It wasn't the press. It was me.

Ran copy through the machine as make-ready, to test the feeding. Machine sounded good, greased up, the vacuum on the feed was good and consistent-sounding, the base underneath the paper goddamn robust, and nothing bad happened. Maisie ran like a fucking saint - that is, to say, ran like she always does when I pull my head out of my ass and pay better attention. Ran 500 more of the 'Thank You' plate, which didn't need strict registration since it had no flip-side to print and stayed pretty far from the left margin. THERE WAS NO GODDAMN INCIDENT. The ink went on like butter and the new rubber blanket was great. It was beautiful. I nearly cried from joy, but I'm not a camel - I have no water left in me from all that damn crying I've done.

I did notice it was a little far to the left since I hadn't adjusted either the plate or the paper to align. Clint's warning rang in my head to keep that feed side centered to avoid trouble. I moved the paper over on the second plate to where I'd been printing all month, off-center to the left.

And the damn problem came straight back. Paper flying down into the machine again.

I stopped, moved the paper back into the center, and it went away.

Lesson to be learned, kids: register, register, register good.

I'm going to reprint the plates yet to do. A time-sucking task, but if the plates run as smoothly as this just because I nudge them over a quarter of an inch, then it's well worth it. Did 1500 sheets without almost any loss. Only got stopped by needing to reprint plates. Otherwise, Maisie was good and I was good to keep going. GOOD DAY.

Larry from Printing Equipment and Supply also called back with info on the missing part of the feed table - when he relayed to me the price for one of the missing pieces, 140 hot buckaroos, I responded that was well more than half of what I paid for the whole damn press in the first place. He joked I could add it and drastically increase the value of my press. You know, if I wanted to resell or something. HA!


April skies, February blankets.


Space heaters doing their best - once the room hit 40ish degrees, though, the temperature was a non-issue.



Back to the drawing board for a minute.